Frequently Asked Question
Calibrating an IVEO Touchpad.
Last Updated 9 years ago
To calibrate your IVEO Touchpad:
- Replace the initial setup pattern with one of the maps that was included with the touchpad. If you no longer have a map, print a new copy by opening a sample map file in IVEO Creator Pro, Creator or Viewer and then using the Print command from the File menu. Open the touchpad clamp and place the map in the upper left corner of the touchpad, then close the clamp to hold the paper.
- Go to the Touchpad menu and select 'Calibrate from Current Image'.
- IVEO will say, "Touch top left corner of the image." Touch the top left point of the embossed corner on the top left (Note, this embossed corner is below the row of boxes). IVEO will say, "Press space to confirm." If you touched the wrong place, continue touching until you believe you have touched the correct point and then press the space bar.
- You will then be prompted to "Touch the bottom right corner of the image." Touch the bottom right point of the embossed corner and when you have touched the correct place, confirm by pressing the space bar.